View Single Post
#22: 08-30-2011, 01:21 AM
 
 kombat_certified
kombat_certified's Avatar
Title: New Member
Location: Minot, ND / Missoula, MT
Car: 98 Legacy GT / EJ205 Swap
Posts: 16
iTrader: (0)
Send a private message to kombat_certified Find all posts by kombat_certified Reply With Quote
Thanks for sharing your knowledge with this whole thread, much appreciated.

Perfect, thank you. I was wondering if I cut out that metal it would be ok. I also notched out the crossmember for my uppipe to fit, was just going to weld in a reinforcement. Noticed in here you said not to, hope it holds up.