View Single Post
#11: 08-19-2011, 06:53 AM
 
 Biggu
Biggu's Avatar
Title: Senior Member
Location: Columbus/Galena, OH
Car: 2012 Sportwagon TDi,92 SC300 drift car
Posts: 304
iTrader: (10)
Send a private message to Biggu Find all posts by Biggu Reply With Quote
Quote:
Originally Posted by Imprezsing04 View Post
Your car looks really nice!

So it is pretty noticeable in person? I'm pretty much sold but just trying to think how it'll look on my obp. Also, my sidemarkers aren't cleared wondering if I should clear them. But the whole point of the laminx is partially so I could avoid baking and taking apart my headlights to black them out. Hmm
yea its noticeable in person. It changes darkness depending on how light it is outside, not nearly as dark as it was on my speed 3.

that was gun smoke i think. It didnt help that the back housing was black as well so it looked super dark.


Quote:
Originally Posted by underground000 View Post
Any tips on install?? I am more curious about the bubble part/projector area. The part that sticks out I am sure a heat gun is needed

honestly wasnt too bad, just take your time.on it. I lined up the corners and then started on the bubble and worked my way out from there. best thing about lamin x is that you can remove it and re apply as needed as long as its still wet. I didnt use a heat gun at all.
The Following 2 Users Say Thank You to Biggu For This Useful Post:
Imprezsing04 (08-22-2011), underground000 (08-19-2011)