Thread: Exhaust Install
View Single Post
#10: 05-02-2011, 06:04 PM
 
 mwiener2
mwiener2's Avatar
Title: Trunk Monkey Chief
Rank: Premium Donator
Location: Boulder, CO
Car: 2005 Rocketback, 2010 Clown Car
Posts: 12,609
iTrader: (13)
Send a private message to mwiener2 Find all posts by mwiener2 Reply With Quote
Quote:
Originally Posted by xero287 View Post
Hmmm, so...if I eventually get a 3 inch midpipe that'll just be a direct install with no donut or adapter correct? And I'd just use bolts instead of the spring bolts right?
Your aftermarket downpipe replaces the factory down and mid pipe. Unless you bought a 2-piece aftermarket downpipe, there are a few out there. You would need to get a matching catback. Just use regular bolts with a flat gasket.

Quote:
Originally Posted by xero287 View Post
So, spring bolts arent necessary at all then right? can I just use the same bolts without the spring?
You'll probably run out of threads before it became tight if you use the spring bolts without the springs.
__________________
(Updated 2/7/13)
2005 Outback FMT
Spec Yaris