View Single Post
#7: 05-07-2010, 11:28 PM
 
 amp27
Title: Banned
Location: 死点百万。活泼点
Car: 96 gt. awd. All we'll Drive.
Posts: 1,422
iTrader: (0)
Find all posts by amp27 Reply With Quote
sweet zues. i would love to see it. i have access to all the autodesk programs but i have only used inventor in my engineering class at school. i had inventor on my old win 7 but lost it when the RC ran out. so i am just getting it back on now. since i am a student i can get 13 month serials till i grad from college haha. when i get off work tomorrow i come right home and whip some models up.

but yes. the PLTW program that our school is doing is focused around autodesk inventor. that all we have been "trained" in. we got 2010 at school and i just saw today i can get 2011. so excited. i was wacthing youtube vids on it . direct multiplication is yum yum.

i also wanted to design an entire chassis for my rc truck using 3/16 steel rod. like the chassis would be everthing, the base, roll cage, like a sandrail. of course i have never used the 3d point plot stuff yet. but how hard can it be. ...draw points. draw path...sweep and presto

Last edited by amp27; 05-07-2010 at 11:34 PM..