View Single Post
#37: 12-24-2009, 08:10 AM
 
 CasopoliS
CasopoliS's Avatar
Title: Vendor I
Location: Toledo, OH
Car: Yes.
Posts: 5,433
iTrader: (147)
Send a private message to CasopoliS Find all posts by CasopoliS Reply With Quote
itsme, this should be a fun project... excited to see what you do.

The hot pipe will be very short, and the BPV style and location should make things easier as well. Its interesting, the BPV is on the hot pipe now.. and it dumps immediately into the intake tube. You could get away with putting a hose "nipple" on the hot pipe and using a standard 90 degree BPV like a Forge. Then just use some 1" or 1.25" heater hose as a recirc hose that goes between the BPV and intake. The cold pipe will be close to current designs. The 2010 is setup perfectly for a FMIC.

While you are at it, I would design a replacement hot pipe for the stock TMIC. Might as well. People would buy it... since the stock hot pipe is so long and plastic....

__________________
www.cubbypods.com - back in stock!

Last edited by CasopoliS; 12-24-2009 at 08:17 AM..