View Single Post
#1: 04-16-2009, 05:42 PM
JDM Rain Visor installation
 
 scoobydoobie
scoobydoobie's Avatar
Title: Scooby
Location: VA
Car: 05 ABP LGT unlimted
Posts: 6,477
iTrader: (86)
Send a private message to scoobydoobie Find all posts by scoobydoobie Reply With Quote
Finally got around to putting my JDM rain visors on today. Install is not bad, the hardest part was putting the roof mold back in. For some reason my passenger side visor fit easier than the driver's side. Had to bend the driver's side visor a little bit to get it to line up, while the passenger's side fit right on.

Purchased from EDO Performance. Came with 12 brackets and primer. Some people's visor's come with the directions written in Japanese, but mine came with them in English, so I scanned them. Ignore the part about bracket "C" as its not needed on the Legacy install. I also ended up with two extra brackets, using 4 "A" brackets and 1 "B" bracket on each side.



Other helpful posts:

http://www.legacygt.com/forums/showp...&postcount=185
http://www.legacygt.com/forums/showp...&postcount=199
http://www.legacygt.com/forums/showp...&postcount=200

And a couple quick shots I took after getting mine on:



Sponsored links