View Single Post
#1: 04-04-2005, 03:27 PM
Fully independent fogs lights
 
 Deer Killer
Deer Killer's Avatar
Title: 50% air
Car: 05 LGT
Posts: 4,299
iTrader: (4)
Send a private message to Deer Killer Find all posts by Deer Killer Reply With Quote
This mod will enable you to keep you fogs on with your high beams and use your fogs with your parking lights only. This walkthrough shows the wiring points only, not the dissassembly, or how to do your wiring. Standard disclaimer applies, you may break your car at your own risk.

1. First pic - overview, shows three locations you need to modify. From left to right: Blue connector from the mirror control/wiper heater assembly. Fog relay/relay assembly. Left stalk connector.

2. Second pic rear of relay assembly. With the relay assembly pulled out, cut the blue/white wire, secure the loose end from the car, and tap into the blue/white wire coming from the relay assembly.

3. Third/fourth pic. Find the violet wire on the blue connector, and attach your tap from step two here. Instead, you may also wire your tap into constant on or ACC, if you don't like your parking lights being on to have your fogs on.

4. Fifth pic. When looking the the front most part of the connector you will see a white/red and a black/black wire on the the same edge. Splice these two together, without severing either. (Careful, as there is another black/black on the other side which I did not check to see what it was)
Attached Thumbnails
Click image for larger version

Name:	1.jpg
Views:	2459
Size:	111.3 KB
ID:	5850   Click image for larger version

Name:	2.jpg
Views:	1870
Size:	74.4 KB
ID:	5851   Click image for larger version

Name:	3.jpg
Views:	1490
Size:	75.4 KB
ID:	5852  

Click image for larger version

Name:	4.jpg
Views:	1572
Size:	73.8 KB
ID:	5853   Click image for larger version

Name:	5.jpg
Views:	1682
Size:	76.4 KB
ID:	5854  
Sponsored links