Subaru Legacy Forum Index Subaru Legacy Forum Index
 
Home - Vendors - Rules - Forums - Reviews - vBGarage - Join this forum! - Get Todays Posts - Wiki - Members - VB FAQ - Search
img img img
 
Go Back   Subaru Legacy Forums > Search Forums
Reload this Page Search Results
User Name
Password

Page 1 of 10 1 23 > Last »
Showing results 1 to 25 of 250
Search took 0.05 seconds.
Search: Posts Made By: tytek
Forum: Wheels/Tires 05-19-2013, 07:43 AM
Replies: 151
18x8 Suggestions?
Views: 2,959
Posted By tytek
Those are super sweet. Out of my price range, but...

Those are super sweet. Out of my price range, but I'd rock them on my 5th gen... :wub:
Forum: Southern California 05-18-2013, 10:39 AM
Replies: 2
FS: (SoCal) IMMACULATE 2011 Legacy GT wheels+tires+TPMS (LESS THAN 500 MILES)
Views: 199
Posted By tytek
You still haven't sold them? :eek:

You still haven't sold them? :eek:
Forum: Fifth Generation Legacy (2010 - ) 05-13-2013, 06:09 PM
Replies: 10
TOB replacement under warranty - new clutch or not?
Views: 203
Posted By tytek
Thanks for the input. I am leaning towards...

Thanks for the input. I am leaning towards getting the clutch and PP replaced, but may wait until it is apart to make up my mind.

I have a mod friendly dealer and I had my cars serviced with the...
Forum: Fifth Generation Legacy (2010 - ) 05-12-2013, 05:08 PM
Replies: 10
TOB replacement under warranty - new clutch or not?
Views: 203
Posted By tytek
TOB replacement under warranty - new clutch or not?

I am getting my throw-out bearing replaced under warranty due to it being noisy. If my clutch shows signs of wear, Subaru will replace the disk, pressure plate and flywheel (maybe?) under warranty. ...
Forum: Fifth Generation Legacy (2010 - ) 05-12-2013, 10:41 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
I exchanged a few texts with Lee prior to going...

I exchanged a few texts with Lee prior to going down this road and Koni didn't have any measurements for 5th gen LGT. I'll update him of my progress, maybe even take him out to lunch if his schedule...
Forum: Fifth Generation Legacy (2010 - ) 05-11-2013, 10:36 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
That is quite nice of you. :wub: I measured...

That is quite nice of you. :wub:

I measured my ride height again with trunk full of work stuff and the rear is not too much higher than the front. But I do need to raise my headlights, as they are...
Forum: Naturally Aspirated Powertrains (2.5i, 3.0R) 05-08-2013, 06:43 PM
Replies: 224
My E85 Raptor SC 2.5i build
Views: 9,693
Posted By tytek
Man, those auto gears are long! :lol: Sounds...

Man, those auto gears are long! :lol:

Sounds great :wub:
Forum: Fifth Generation Legacy (2010 - ) 05-04-2013, 07:03 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
I am assuming you are asking me? Yes, I do. It is...

I am assuming you are asking me? Yes, I do. It is listed under my avatar as a 2011 LGT Limited. I used to have a 4th gen back in '04, that I sold in '08.

Here are my most recent measurements:...
Forum: Fifth Generation Legacy (2010 - ) 05-04-2013, 04:55 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
My RCE springs did not come with bumps stops...

My RCE springs did not come with bumps stops :icon_conf
Forum: Fifth Generation Legacy (2010 - ) 05-04-2013, 05:22 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
That's what I did with my rear bump stops - just...

That's what I did with my rear bump stops - just shortened them by one corrugation. I left the front ones untouched, will see if that was a smart move.
Forum: Fifth Generation Legacy (2010 - ) 05-03-2013, 05:16 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Agree with you on the handling improvement. Much...

Agree with you on the handling improvement. Much less body roll and it is quite hard now to make the PPS' sing, or it takes a lot more balls and quite a bit more speed :wub:

I still need figure...
Forum: Fifth Generation Legacy (2010 - ) 05-03-2013, 05:10 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Yes I do. But due to the increase in contact...

Yes I do. But due to the increase in contact patch (225 vs. 245) they are ultra loud on concrete and rough surfaces. They do quiet down a lot on smooth roadways. I am still considering adding sound...
Forum: Fourth Generation Legacy (2005 - 2009) 05-01-2013, 06:52 AM
Replies: 86
My Legacy Rebuild...
Views: 993
Posted By tytek
How about a killerb oil pick up, since you have...

How about a killerb oil pick up, since you have everything apart?
Forum: Fifth Generation Legacy (2010 - ) 04-28-2013, 03:22 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Seems like you are seeing a similar height...

Seems like you are seeing a similar height difference between right and left too. :confused: Although my rears are higher, due to me using the WRX front struts, which in turn are lower than LGT KYB...
Forum: Fifth Generation Legacy (2010 - ) 04-28-2013, 07:58 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Yes, the Michelins are 245/40/18 and are the...

Yes, the Michelins are 245/40/18 and are the Pilot Super Sport summer tires. On concrete highways they are so loud that I can barely talk without raising my voice. On smooth, new asphalt, they are...
Forum: Fifth Generation Legacy (2010 - ) 04-27-2013, 08:44 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Thanks for doing the initial research. ...

Thanks for doing the initial research.

After install, the fronts were 68.5cm, while the rears were 71.5cm. The rears have probably settled a little after driving for about 50 miles. I will check...
Forum: Fifth Generation Legacy (2010 - ) 04-27-2013, 08:09 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
BTW, did I say that the RCE/Koni combo is stiff?...

BTW, did I say that the RCE/Koni combo is stiff? Rattle your fillings stiff. Not sure if I like it for DD yet. Combined with my Michelin Pilot Super Sport, which are loud as $&@), the car does not...
Forum: Fifth Generation Legacy (2010 - ) 04-27-2013, 05:46 PM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Installed my 09 WRX Koni inserts using from 09...

Installed my 09 WRX Koni inserts using from 09 WRX donor strut bodies. I had done these swaps before on Subarus, Audis, BMWs, Fords, but this was the first time that I had no help. It is easier and...
Forum: Fifth Generation Legacy (2010 - ) 04-26-2013, 05:19 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
If you want the additional 1/4" drop up front, go...

If you want the additional 1/4" drop up front, go ahead with the KYB ones. It should not be a big deal, as your drop of around 1" should keep your camber within OEM spec. I wouldn't sweat it at all,...
Forum: Cars For Sale 04-17-2013, 03:13 PM
Replies: 32
FS (OH) - 2005 Legacy 2.5 GT Wagon 5MT
Views: 3,853
Posted By tytek
:lol:

:lol:
Forum: Fourth Generation Legacy (2005 - 2009) 04-16-2013, 11:34 AM
Replies: 12
Deteriorating Wagon sunroof seal (pics)
Views: 231
Posted By tytek
It is a code name that was coined a long time...

It is a code name that was coined a long time ago. Too lazy to PM you the details. I'm sure someone with more motivation will help explain in private though.
Forum: Fifth Generation Legacy (2010 - ) 04-16-2013, 11:26 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
Yeah, I did see that in the other thread. Will...

Yeah, I did see that in the other thread. Will take a bunch of measurements to see if the OD and ID are the same between '09 WRX and '11 LGT strut housings. ID will obviously be hard to do in an...
Forum: Fifth Generation Legacy (2010 - ) 04-16-2013, 05:23 AM
Replies: 119
Koni inserts built with '13 OEM housing
Views: 2,691
Posted By tytek
My Koni inserts and RCE blacks are on the way....

My Koni inserts and RCE blacks are on the way. Also got 08+ WRX front donor struts. Plan to install next weekend. Will take plenty of pics and advise of the results.

It is best to go full soft on...
Forum: Fifth Generation Legacy (2010 - ) 04-13-2013, 05:06 AM
Replies: 80
2009 WRX OEM setup on 2013 Legacy 6MT
Views: 4,195
Posted By tytek
Bought a set of WRX Konis and RCE blacks. Will...

Bought a set of WRX Konis and RCE blacks. Will try to put them on next weekend. Now looking for donor strut bodies, but have a strong suspicion that my stock ones will work.

When are you putting...
Forum: Exterior/Aesthetic 04-10-2013, 07:35 PM
Replies: 15
accident repair question
Views: 262
Posted By tytek
I doubt insurance will replace the other...

I doubt insurance will replace the other headlight. If the bumper is in good shape, they will blend it in. Most insurers will nickle and dime you to death. Find a good quality body shop of your...
Showing results 1 to 25 of 250
Page 1 of 10 1 23 > Last »

 
Forum Jump
Remove advertisements

All times are GMT -6. The time now is 01:34 PM.

 
img img img
LegacyGT.com - Archive - Top
Back To The Top   img img Back To The Top
Zoints SEO v2.3.0 by Zoints & Computer-Logic.org

vBulletin Optimisation by vB Optimise.