So this is the path that I went for my install.
All the tools I used for the install
http://imagizer.imageshack.us/v2/320x240q90/801/5n20.jpg
Purchased at O'Reilys auto for 11.99$, the only reason I went with these is because they were the only red ones at the store. These have the on/off switch but I did not keep the switch because I hard wired them in.
http://imagizer.imageshack.us/v2/320x240q90/855/am8g.jpg
Basically, if you hard wire, you cant use the on/off switch
http://imagizer.imageshack.us/v2/320x240q90/534/2dlq.jpg
The insides of the 12V socket.
http://imagizer.imageshack.us/v2/320x240q90/856/4za1.jpg
First I had to pop off the backing of the lights, then pop out the LEDs.
http://imagizer.imageshack.us/v2/320x240q90/824/m269.jpg
Second step is to grind the area down where you will be mounting the LED circuit board, as you can see I did it where the Subaru kit gets mounted. Make sure not to grind down too much, check the fitment as you go, you want to make sure it is very snug when sliding the LED circuit board in. Also, it makes it tons easier if you grind down the edges of the circuit board to ensure there are not sharp edges when trying to slide it in the slot.
http://imagizer.imageshack.us/v2/320x240q90/42/8jn3.jpg
After the grinding I positioned the circuit board so that the middle of it was dead center of the diffuser ring for maximum use of the lights.
http://imagizer.imageshack.us/v2/320x240q90/833/3ws2.jpg
The other corner of the cup holder, they are very snug and will not move at all.
http://imagizer.imageshack.us/v2/320x240q90/541/h5qt.jpg
After the two circuit boards were in position I used electrical tape to bring the wires to a central spot. This package has TONS of extra cable.
http://imagizer.imageshack.us/v2/320x240q90/24/enpx.jpg
I cut about 3ft of the extra cable and since the cable is very fine I used a bridge to step up the wire gauge, and cleaned the look up a little with a maintenance loop.
http://imagizer.imageshack.us/v2/320x240q90/163/8l9k.jpg
It was very simple to wire in, I just used the purple with dots for the positive, and the black with dots as the ground. I went directly into my heated seats connecter so that they turn on when necessary. Credit goes to previous posts.
http://imagizer.imageshack.us/v2/320x240q90/27/y68a.jpg
The final look, sadly I only have a Iphone as my camera and it does not capture the brightness these lights give off. The light can be seen all around the diffuser at a equal intensity. I am extremely satisfied with the overall look and have no complaints at all!
http://imagizer.imageshack.us/v2/320x240q90/811/x79w.jpghttp://imagizer.imageshack.us/v2/320x240q90/835/ey8h.jpg
Hopefully this helps someone out that is thinking about doing this install. Total I spent no more than 20$, and maybe 1-2 hours worth of work, only because I need everything PERFECT and kept going back to change things. Thanks again to all the previous posts that helped me get this done properly.
Have a great day and good luck!
-Brenden