Jump to content
LegacyGT.com

Z0rr0

Members
  • Posts

    121
  • Joined

3 Followers

Personal Information

  • Location
    Gilbert, AZ
  • Car
    05 LGT, PTE6262, METH, 6-SPEED

Z0rr0's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Lookin' good. Keep me posted on how the car is doing.. either via text or here.. should be a fun ride
  2. if only the wife's Baja had plates.. i'd go.. theres no way my legacy can go "Off road"
  3. between 5 and 15 or so.. usually around 10.
  4. you'll be fine. 1/2 of the people that show up don't even have subarus anymore. it's a decent meet most of the time.
  5. Thursday nights @ Subaru superstore of chandler. most people get there around 8 ish.
  6. clutch and flywheel. you'll also need the clutch master cylinder since you are going from 5eat to 6MT i do not believe you have to change the ECU.. flash a manual rom onto it.
  7. those work only w/ an R180 and legacy hubs. (can be made to work on the impreza swapping the outer CV.)
  8. for anyone doing an EARLY 04 sti trans, (stubbed axles). mine has always leaked, after further research, not only do you have to remove the stubs, you also have to replace the "sundial" or differential retainer on the sides of the transmission for our male style axles to fit properly. Sundials (retainer differential) 38342AA161 (2) dealer claims same l/r O-rings 806900150 (2) may not be required but ordered to determine. Numbers above for a 2005 STi. Local dealer claims sundial part numbers are the same for '02 through '07 model years. Having the above part numbers should allow a "pinned" '04 US STi to be converted to non-"pinned" and direct fit a STI or LGT front axle. The stub shafts will require removal from the "pinned" transmission's differential. Be sure to review the appropriate Service Manual for installation and adjustment procedures.
  9. ^^ haha.. driver says, "my parents are gonna be so pissed!" :lol::lol:
  10. you'll also need an AUTO legacy drive shaft.. and 07-09 Spec B rear axles. Please go read the thread. this question is answered about 1000 times.
  11. The STI R180 requires the R160 flange to be swapped. The specB R180 has the R160 flange from the factory.
  12. was there ever any update to this? i wouldn't mind changing to 5x114.3, and i'll need new hubs soon enough anyway.
×
×
  • Create New...

Important Information

Terms of Use