Subaru Legacy Forum Index Subaru Legacy Forum Index
 
Home - Vendors - Rules - Forums - Reviews - vBGarage - Join this forum! - Get Todays Posts - Wiki - Members - VB FAQ - Search
img img img
 
Go Back   Subaru Legacy Forums > Search Forums
Reload this Page Search Results
User Name
Password

Showing results 1 to 16 of 16
Search took 0.01 seconds. Search: Posts Made By: GEORGEROV
Forum: Second Generation Legacy (1994 - 1998) 05-02-2013, 04:00 PM
Replies: 19
Views: 189
Posted By GEORGEROV
Cool Most manufacturers have a percentage error built...

Most manufacturers have a percentage error built in to the speedo , usually about 5% fast , so that they can't be blamed for you breaking the speed limit when the gauge says you were not . Also worn...
Forum: Third Generation Legacy (1999 - 2004) 05-02-2013, 03:35 PM
Replies: 4
Views: 121
Posted By GEORGEROV
Cool I've heard of this problem on Foresters when a...

I've heard of this problem on Foresters when a slave cylinder has been replaced . Apparently if its mounted too close to the transmission there is not enough free play for proper operation . maybe...
Forum: Third Generation Legacy (1999 - 2004) 05-02-2013, 03:06 PM
Replies: 7
Views: 134
Posted By GEORGEROV
You need to check the voltage to the bulb...

You need to check the voltage to the bulb connector to see if you are getting voltage there or not .
Forum: Third Generation Legacy (1999 - 2004) 05-02-2013, 02:57 PM
Replies: 7
Views: 143
Posted By GEORGEROV
Hi 00 , You're current Barum tyres are made by...

Hi 00 , You're current Barum tyres are made by Continental and get great write ups on German sites . Rated as summer tyres and not all season .
The steering wheel shake at speed sounds like...
Forum: First Generation Legacy (1989 - 1993) 04-06-2013, 05:07 PM
Replies: 6
Views: 145
Posted By GEORGEROV
Measure the voltage reading across the battery...

Measure the voltage reading across the battery terminals with the engine running . Should be about 13.5 volts . If that is correct then the alternator is charging ok . Problem might be a current...
Forum: Fourth Generation Legacy (2005 - 2009) 11-02-2012, 10:43 PM
Replies: 29
Views: 706
Posted By GEORGEROV
It is good pracise generally to switch off all...

It is good pracise generally to switch off all accessories before switching off the ignition and is a cheap solution to your problem .
Forum: Fourth Generation Legacy (2005 - 2009) 08-21-2012, 05:59 PM
Replies: 10
Views: 372
Posted By GEORGEROV
If you just recently noticed the smoke and it was...

If you just recently noticed the smoke and it was driving ok then why not just have the joint refilled and a new boot put on . Might be fine and no damage to the joint .
Forum: Third Generation Legacy (1999 - 2004) 08-21-2012, 05:52 PM
Replies: 9
Views: 272
Posted By GEORGEROV
Ideally you should read 13.5 Volts across the...

Ideally you should read 13.5 Volts across the battery when the motor is running . Is the drive belt in good condition and tight ?. Are electrical connections to the alternator sound ? . Especially...
Forum: Third Generation Legacy (1999 - 2004) 08-21-2012, 05:30 PM
Replies: 9
Views: 272
Posted By GEORGEROV
If you leave accessories on overnight then you...

If you leave accessories on overnight then you will flatten the battery . Jump starting it to get it going and running for a while wont necessarily give enough charge to start it again after shutting...
Forum: Third Generation Legacy (1999 - 2004) 08-21-2012, 05:19 PM
Replies: 70
Views: 3,120
Posted By GEORGEROV
Just general wear and tear in the driveline maybe...

Just general wear and tear in the driveline maybe . Universal joints in the driveshaft and slackness/backlash in the differentials .
Forum: Suspension/Brakes 12-09-2010, 01:45 PM
Replies: 15
Views: 1,987
Posted By GEORGEROV
Wink On the earlier models there is an abs diagnostic...

On the earlier models there is an abs diagnostic connector tucked up behind the dashboard at the drivers side(rhd) heater unit with an associated earth pin probe for pulling fault codes. This will...
Forum: Naturally Aspirated Powertrains (2.5i, 3.0R) 12-04-2010, 04:48 PM
Replies: 22
Views: 1,080
Posted By GEORGEROV
Cool When the mileage on an engine mounts up then the...

When the mileage on an engine mounts up then the specs for that engine change due to wear and tear. I ran a high mileage Merc 500 v8 which when I bought it had tappet noise for a minute and a half...
Forum: Suspension/Brakes 12-02-2010, 04:22 PM
Replies: 9
Views: 345
Posted By GEORGEROV
Wink www.rockauto.com will do a pair of rear springs...

www.rockauto.com will do a pair of rear springs for $100 plus shipping.
Forum: Naturally Aspirated Powertrains (2.5i, 3.0R) 11-29-2010, 04:30 PM
Replies: 10
Views: 527
Posted By GEORGEROV
Cool How about an air leak on the induction side....

How about an air leak on the induction side. Check all the vacuum hoses are secure with no splits or are perished.
Forum: Naturally Aspirated Powertrains (2.5i, 3.0R) 11-29-2010, 01:44 PM
Replies: 8
Views: 343
Posted By GEORGEROV
Cool Possibly the heat shields on the exhaust becoming...

Possibly the heat shields on the exhaust becoming loose?.
Forum: Naturally Aspirated Powertrains (2.5i, 3.0R) 11-28-2010, 05:02 AM
Replies: 22
Views: 1,080
Posted By GEORGEROV
Cool Sounds more like top end rattle from the...

Sounds more like top end rattle from the hydraulic tappets (valve lifters). Try using a thicker oil.
Showing results 1 to 16 of 16

 
Forum Jump
Remove advertisements

All times are GMT -6. The time now is 05:53 AM.

 
img img img
LegacyGT.com - Archive - Top
Back To The Top   img img Back To The Top
Zoints SEO v2.3.0 by Zoints & Computer-Logic.org

vBulletin Optimisation by vB Optimise.