Jump to content
LegacyGT.com

Oregon OBXT

Members
  • Posts

    102
  • Joined

Oregon OBXT's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Scroll down to post #65. http://legacygt.com/forums/showthread.php/drivers-window-switch-died-today-38349p5.html
  2. Jurassic thread revival. Thanks to AWD_Warrior for the post! Amazing that he hit one out of the park with just 3 posts to his name! Only comment to add here is to make sure that the fork at the end of the button engages with the actual electronic switch below upon reassembly. Seems like a 'duh' but after pulling apart and putting back together a few times you become more focused on the switch action than on the alignment. If it gets off, just use a micro screwdriver to pull the switch back to center and the fork should again lock onto it. And lastly, verify correct operation before sealing the door panel back up. Two more tidbits: Fortunately I had felt tape as you destroy the OEM pulling it apart. I wrapped the it twice. Without I'm sure it would chatter with it being plastic on plastic. The other tidbit is to add felt tape along the door panel where the fake leather wraps around. Everywhere else along the edge has a foam strip. This will eliminate a potential noise source.
×
×
  • Create New...

Important Information

Terms of Use