What language are you writing the code in?? (just curious)
Also, I know that you spoke about an aux input in the past, how is that connected to the board, and what type of inputs will it support?
Thanks!
When you get off the gas, the fuel is cut so it goes lean... You may just want to do some searching/communicating with some folks at Innovate... I don't know which is better, more resolution around Stoic or knowing exactly how lean/rich you are...
RE: LC1 outputs...
You might want to set up the range a little bit narrower... anything over 17-18 is way lean...
I'd ask the folks at innovative for some advise if I were you...
lolsol.. The new features sound awesome! What type of input(s) are you planning for future use? 8mm jack perhaps? FWIW, I *really* like the curve of the leds on the 1st prototype.
I was hoping you'd come up with something like this (similar to the one I shared with you earlier that was made for the Forester).
Something like this could be a solution for all years but the 05 guys would have to keep their original plugged in so the airbag light wouldn't come on...
So freaking awesome!!!!
BTW, if you ever want or need any inspiration just check out this multi/meter thingy that a guy made for the Forester XT a few years back:
Pics/more info:
http://scoobymods.com/forums/showthread.php?t=3855&highlight=mo_boost
If your headlights are on (and your instrumentation has been dimmed) it will take them to full brightness until you press the button again, or you turn the car off.