Well, attached are pictures of the endlink connection, mount connection, and the endlink and mount after being disconnected.
Whiteline recommends doing this install with your cars suspension under normal load. Jacking it up makes it easier, just make sure when you tighten everything in the end, it is with the car on level ground again.
For my endlink connection, I needed two 17mm sockets. Standard wrenches would be easier. Unbolt the sway bar from the endlinks.
Next, undo the mount connection. For my setup, I needed a 6mm allen wrench. Stock may require a different size/type. Once you have removed the mounts, slide the swaybar out from under the car (it should be over your exhaust, so don't go yanking).
NOTE! For the front swaybar, you will need to remove a protector plate which has 4 12mm bolts. The front two need a 12mm wrench to hold the nuts on the upper part of the brace.
Slide your new super awesome-O swaybar in place, making sure it is correctly oriented to clear the exhaust and or CV bars.
Take your new bushings, and grease those badboys up on the insides. Throw some grease on the bar at their connection points too. Put them on your bar.
Line your bar up, get the bushings oriented in your mount, and go ahead and remount them. Don't completely torque them down yet though!
Make sure the ends are lined up with your endlinks. This may require you pulling the endlinks into position to line up with the bar.
Re-bolt the bar to the endlinks. If you have an adjustable bar, hook it up on the setting you deem fit!
Go back and retorque the mount bolts.
Get your tools, get out from under your car, and get ready to feel teh awesome.
!!!#NOTE#!!!
The bushings are "directional". They will go in easily one direction, and not so easy nor flush the other. Make sure you have them oriented properly. Also, do not grease up the exterior of the bushing, nor any extra area on your swaybar. Under compression, if any of these are done improperly, your bushing may pop out while you are driving. This is not good.
(Sorry for the sh#t pictures. I will have good ones up in about a week)