Jump to content
LegacyGT.com

scoobiedoo05

I Donated
  • Posts

    9
  • Joined

About scoobiedoo05

  • Birthday September 11

Personal Information

  • Location
    Minnesota
  • Car
    2005 LGT
  • Occupation
    Wilson Tool

scoobiedoo05's Achievements

Rookie

Rookie (2/14)

  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Ya the clearance is good on all of them. This past summer we took the engine out and replaced all the valves, the cylinders, and bearings
  2. We took the seats and springs off of one on the intake side and one on the exhaust side and slid them back and forth to see if they were grabbing or bent at all
  3. we took the head off that side and tried out the valves ourselves and they were fine. spark plugs, coils, injectors and such have also been replaced. any chance it could be ecu or a wire harness?
  4. Cylinders 1 & 3 are fine at start up but after running for 5 minutes or so they misfire
×
×
  • Create New...

Important Information

Terms of Use