Got a question, im on the koni/epic setup have been for a couple months now. Just recently i got 10mm wheel spacers for the rear cuz i didnt like how my rota grids we set in more than the fronts. They look about even no but the problem is that when i go over bumps or a decent uneven surface my rear fenders scrape. It seems to be only on the outer face of the tire. Should i get strut spacers to help this or get my fenders rolled. Was gonna get them rolled/pulle but wont that bring the look of the tires to being not flush any more?
Has anyone with a stromung gotten rid of theirs and gotten something louder? I have the quad tip stromung with a erz catted dp and a sti up for a while now and i think i want something louder. Being at wbm over the weekend and hearing my buddys wrx with a invidia cbe makes mine sound stock, yea i know his wrx sound different. Just looking for some ideas
Im on konis with epics and its low but i kinda want to go just a touch lower. What springs would be good seeing as the epics are 1" in the front and .8" in the rear
Damn. So cutting then to a certan lenghth does not effect anything other than the insert sliding in? It will pull through and bottom out no matter how little i cut, just cant cut too much so the bumps show
Just installed my konis yesterday. Still feeling them out but i now feel a front end clunk. I also replaced the end links n lca bushings with the install.
Just got my konis, stupid question but when you measure on the konis at the bump do you go to the top of the bump, the bottom or try to center it. Either way its a different measurement for the cut on the stock struts?
A little off topic, but would it be wise to get a boost guage and or any recommendations on what brand/kind to get. Was thinking cubby pod if i were to get one