Jump to content
LegacyGT.com

ChefRacer

Members
  • Posts

    418
  • Joined

2 Followers

About ChefRacer

  • Birthday 06/25/1980

Personal Information

  • Location
    Philadelphia
  • Car
    05 M/T ShagginWagon Dom2.5XTR 420WHP
  • Interests
    Trying to get my Son's First word to be BOOST
  • Occupation
    Chef

ChefRacer's Achievements

Proficient

Proficient (10/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Wow, I was just about to buy a used set of brembos...looks like plans change
  2. Why are you getting rid of the qtp cutout? Did you have any leaks or problems with it? How long did you have it on there for?
  3. Those big green eggs sound really cool, I just looked it up. Wish I could swing it, I'd love to grab em from ya. How much would you want for the small one?
  4. I just ended up switching to a differen laptop, now it works perfectly
  5. Your killing me bac with all of these awesome deals, how far are you from Elkridge? My brother lives there.
  6. Damn, I wish I had a good excuse for going down there so I could grab some of those awesome goodies you've got there bac
  7. The only reason Clint Eastwood is alive is because Chuck Norris allows him to be.
  8. It's a vag-com cable, I'm going to be trying those options, just trying to get in touch with people in my area who use this type of setup as well.
  9. Rom raider is reading the correct com port, I'm planning on selling the AP to go with an open source tune. I'm just getting really frustrated here. I just un-installed the drivers for the cable 4 times and reinstalled them again, I just re-downloaded all of the logger and ecu definitions, and even re-booted my laptop a couple of times for good measure. It still doesn't recognize the car being on the other end of the cable. The stupid blue Leds on the end of the cable light up when I plug it into the car, and I've made sure that that is really tight in there. I don't know what to do next.
  10. Ok guys, I'm pretty sure I've installed my cable correctly, and I've downloaded the definitions into romraider, but romraider isn't detecting my ecu when it's hooked up. I still have my AP hooked up, I'm trying to make sure that this works before I dissconnect and sell my AP. Would the AP V1 block romraider from being able to read the ECU entirely? I was under the impression that it would just stop you from being able to write to the ECU. Thanks alot for your help guys.
×
×
  • Create New...

Important Information

Terms of Use