Jump to content
LegacyGT.com

Tmemz

Members
  • Posts

    153
  • Joined

2 Followers

About Tmemz

  • Birthday 04/28/1989

Personal Information

  • Location
    CT
  • Car
    05 OBP 5eat

Tmemz's Achievements

Collaborator

Collaborator (7/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Got a question, im on the koni/epic setup have been for a couple months now. Just recently i got 10mm wheel spacers for the rear cuz i didnt like how my rota grids we set in more than the fronts. They look about even no but the problem is that when i go over bumps or a decent uneven surface my rear fenders scrape. It seems to be only on the outer face of the tire. Should i get strut spacers to help this or get my fenders rolled. Was gonna get them rolled/pulle but wont that bring the look of the tires to being not flush any more?
  2. Has anyone with a stromung gotten rid of theirs and gotten something louder? I have the quad tip stromung with a erz catted dp and a sti up for a while now and i think i want something louder. Being at wbm over the weekend and hearing my buddys wrx with a invidia cbe makes mine sound stock, yea i know his wrx sound different. Just looking for some ideas
  3. Im on konis with epics and its low but i kinda want to go just a touch lower. What springs would be good seeing as the epics are 1" in the front and .8" in the rear
  4. It was really noticeable to see when cut right how much is sucked in to bottom it out. And also how short my cuts were on the bad set
  5. They bottomed out and i got them tourqued dwn to 50 but i can still see the bumps on both
  6. Damn. So cutting then to a certan lenghth does not effect anything other than the insert sliding in? It will pull through and bottom out no matter how little i cut, just cant cut too much so the bumps show
  7. So it sliding in makes it so it does not move? Because i had a clunk after installing them.
  8. Ive got mine torqued dwn to 50 lbs n they bottomed out but the bumps on the konis did not go thru the housing, did i cut too much off then?
  9. Wait so are the bumps on the konis supposed to slide into the old housing or will it sit above it?
  10. Just installed my konis yesterday. Still feeling them out but i now feel a front end clunk. I also replaced the end links n lca bushings with the install.
  11. Just got my konis, stupid question but when you measure on the konis at the bump do you go to the top of the bump, the bottom or try to center it. Either way its a different measurement for the cut on the stock struts?
  12. A little off topic, but would it be wise to get a boost guage and or any recommendations on what brand/kind to get. Was thinking cubby pod if i were to get one
  13. Would it be wise to get new top mounts? If so does it matter what brand they are like Gabriel or what ever a local parts store has in stock?
×
×
  • Create New...

Important Information

Terms of Use