alphatarget1

If there is a hole in the condenser can I just replace it and have a shop recharge the system? I don't know how much compressor oil is left in the compressor/system, and I don't know how a shop determines how much to add...

What are the tightening torques? FSM says 162ft-lb whereas OP said 137ft-lb...

Anybody in Houston/Austin/Dallas can help me with this job? I just ordered an AUP 190N axle assembly for my 05 LGT + the seals.... I have never done one before so I'd like to have someone watch me do it and make sure I don't screw up hahaha.

Just wanted to say "Merci Beaucoup" again! Mine works great and it's been almost a year since I put it in. One question though: Which types of switches would work if I want to replace my current one with a smaller one? I kind of grilled into pocket under the armrest and I just got a replacement to make it look nicer. Do you have any recommendations?

Here are the promised pics. You can take the compartment out (5 screws, one in the back) and then just drill away. I put a grommet in for the speaker cable. I would NOT recommend putting the switch where I put it, since it interferes with the operation of the cup holder cover thing. Putting it on the other side is better. 3/4" drill bit kind of works, but you kind of have to jam it in. I used a 1/2" bit for the speaker cable. I want to find a 20mm ID spacer/washer for the switch since it has to stick out that much to not interfere with opening/closing the cup holder. Oh well. http://farm3.static.flickr.com/2697/4059085245_7216a33b38_b_d.jpg http://farm4.static.flickr.com/3506/4059085249_b0dc0150c4_b.jpghttp://farm3.static.flickr.com/2511/4059085233_14408a7dcc_b_d.jpg

I ended up putting the switch and audio cable under the arm rest. Pics to follow soon.

I just got the kit today and installed it. Took less than an hour. Works wonderfully as advertised. Highly recommended. Merci beaucoup pour votre bon travail!!!

Out of curiosity have you shipped mine yet? Thanks.