Jump to content
LegacyGT.com

tangcla

Members
  • Posts

    381
  • Joined

1 Follower

About tangcla

  • Birthday 12/09/1984

Personal Information

  • Location
    Melbourne, Australia
  • Car
    2004 BL5 Legacy GT

Converted

  • Homepage
    http://www.tangcla.com
  • MSN
    tangcla@tangcla.com
  • Skype
    tangcla

tangcla's Achievements

Rising Star

Rising Star (9/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Hmm, ok. Without asking you to divulge too much information, is it possible to de-solder the interface board easily without damage? (Of course, I don't even want to think about the LCD and the rest of it just yet... )
  2. Andy, how hard would it be to change the LEDs around the pivot point to white? I would like to do that to mine, is the pcb easily accessible to de solder them? Also what voltage do the red LEDs consume?
  3. It's usually when it's idle. Works fine most of the time, I've sealed it off. Would the wiring be able to take more heat if I shrinkwrapped the wire?
  4. My temperature readout went funny yesterday. It's reading 125 degrees C but fluctuates like it's flashing between working (35 degrees) and faulty. On another note - how heat resistant is the wiring and sensor? I'd like to relocate it to wedge in between intercooler fins to get some more realistic and usable temp feedback.
  5. Is there any way of increasing the refresh rate of the temperature sensor aux input? It only updates every few seconds.
  6. I'm almost certain that the tunes by STi doesn't have any different hardware in the gearbox. I think it's part of the ECU tune (ie line pressure) rather than TCU.
  7. I haven't installed my temperature sensor yet. Been too lazy
  8. I have it hooked up but using ambient Forgot to mention, love the plug on the harness!
  9. For those who are looking for a 2.5mm extension lead: managed to find this on eBay. Item number 260750676242
  10. Really? We are talking a out the mode where you swipe the three touch buttons down, right? I tried it last night and it all turned off, I'm sure of it. I'll check it again tomorrow.
  11. I know, but I would like just the bar and no OLED.
  12. I have a few suggestions : * can we get a white LED marker at the 0psi vacuum mark? * ability to turn off OLED but keep the bar LEDs on. Something like a second blackout function? * ability to set OLED timeout to 0 seconds, i.e. Just turn on for boost activity and turn off straight after
×
×
  • Create New...

Important Information

Terms of Use