Jump to content
LegacyGT.com

waltm

Members
  • Posts

    9
  • Joined

Personal Information

  • Location
    RI
  • Car
    '07 Legacy GT

waltm's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Sorry, for some reason I'm not getting notifications of posts or PMs. Sway bars sold through local ad. I believe to funnyman06.
  2. Local pickup only in Bristol. Invidia turbo back exhaust $800 Weathertech front floor mats $80 price drop Front and rear sway bars SOLD locally MOMO Wood trim steering wheel with audio controls (from LL Bean Outback) $150 Car was totaled, parting out full car or stock parts as well.
  3. A J pipe is for the newer FA20 engines. Make sure you ordered the correct downpipe for the EJ series engines. If by y pipe you mean the split before the mufflers on the cat back exhaust, then yes, the Invidia Q300 is the midpipe, y and mufflers.
  4. Are you looking for stock or aftermarket? I have a full Invidia turbo back (catted down pipe and Q300 cat back) that is out of the car as well as a stock downpipe and a coated grimspeed up pipe (I think it was GS) that is still in my totaled 07 that I haven't had a chance to start pulling apart yet. How soon do you need these?
  5. I've had to re-solder one of the switches on both my LGT and my wife's FXT key fobs when one of the buttons stopped working.
  6. Did you only swap in the long block and are using the original ecu, turbo, etc from the FXT? Wouldn't that run fine on the original tune?
  7. Ouch, sorry to see that. Recently had an 07 totaled as well. Guess I should post a farewell thread as well at some point.
  8. Just thought I'd chime in here. I had a similar situation as yz123mx, bought car from auction with two spun bearing. Replace most of the components in the oiling system when the engine was rebuilt but cleaned out the pulleys (or at least I thought they were clean). Logs looked the same as yz123mx's above. Verified wiring to OCV was fine (current draw in log), cleaned and verified operation of valves and swapped OCV from left to right side to see if issue would follow valve or stay on same cam, verified oil flow to right side OCV. No change in logs so replaced intake pulley. Now both side are working fine. Thanks Underdog and everyone else who commented in this thread as it was very helpful to get to the root cause of this. Still have some issues to sort out but at least this one is fixed.
×
×
  • Create New...

Important Information

Terms of Use