Jump to content
LegacyGT.com

piening2150

Members
  • Posts

    42
  • Joined

Personal Information

  • Location
    Toledo, OH
  • Car
    '05 SWP LGT (sold) '05 Caddy CTS-V
  • Interests
    umm... cars

piening2150's Achievements

Contributor

Contributor (5/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Had an ACT flywheel on there prior to the clutch job (both exactly 14.1 lbs by my scale) with no problems, but judging from the look of the old pressure plate/flywheel it was doing plenty of slipping on its own LOL. Just something to get used to...
  2. not broken in yet, only have about 200 mi on it. So far so good, although it does shudder a little when I take off from a stop with rpm under 2000. Unsure if this will improve as it breaks in or if this is just something I need to adjust to with this particular clutch and give it a few more revs than I used to at launch.
  3. My inspection plate would not fit with the 2100 combo either. tried to bend it to fit around the pressure plate but gave up and left it off. Figured it was already somewhat open and located over the crossmember/steering rack was not likely to get splashed/dirty
×
×
  • Create New...

Important Information

Terms of Use