Jump to content
LegacyGT.com

zberk

Members
  • Posts

    19
  • Joined

About zberk

  • Birthday October 12

Personal Information

  • Location
    Elk Grove, CA
  • Car
    '09 Legacy 2.5i SE
  • Interests
    drums, golf, subarus
  • Occupation
    account executive

zberk's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. I used the real thin stuff that showed a pic of a circuit board and found it pretty difficult to see it flow. If you have a staionary magnifying glass, it might be doable with the thin solder. The points to solder are much smaller than they appear in the pics so you might want to see the area you're working with first. I hope I don't have to do this again, but if I did, I'd go with a bit thicker solder.
  2. I just did it. Man those things are small and hard to solder when you just had a double espresso! It worked, though!! Thanks again to those who blazed this trail!
  3. Thank you crazy pilot! Mine just started this problem and was hoping someone would have pics. Looks totally doable...
  4. Caught a Newport Blue GT lowered w wheels at corner of Laguna Springs and Laguna on Wednesday. I was in my 2.5 Newport Blue Legacy. Seen you around town a few times... Nods, dueces.
  5. Dirty silver LGT with wing and bike racks coming out of in-n-out onto E Stockton in Elk Grove @ noon.
×
×
  • Create New...

Important Information

Terms of Use