Jump to content
LegacyGT.com

Max626

Members
  • Posts

    76
  • Joined

Personal Information

  • Location
    NYC
  • Car
    98 Legacy GT Wagon/ 05 G35 Sedan
  • Occupation
    Diesel Mechanic

Max626's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. I figured that might be an issue, I’ll continue to fiddle with it and see what I come up with
  2. 3 out of the four bolts line up and I put washers up front….the powered seats was simple to wire up (power/ground). I won’t say the seats are fully secure with just the three bolts but it’s hardly noticeable you really have to shake it to feel it.
  3. I have a BG wagon that I retrofitted some 05/06 Gt seats in. I’m trying to get the heated seat portion to work. The BG uses a 2 wire system (High/low) where the 05 has 4 settings. Based on that chart I just need to provide voltage for the high and low setting and leave the other two wires untouched? Or does the 05 have a separate module that controls the heated seat function?
  4. Well in your case since you have a JDM right an drive it would be on your right underneath the mirror switch
  5. Left side right under the mirror switch there is a small panel that gives you access to the OBD port
  6. I tried searching but can only find stuff for the newer models, does anyone have the wiring diagram for the 2gen. And if you happen to have the JDM folding switch for sale hit me up .
  7. Anyone parting out or lives near a you pull it, I’m looking for a full set with keys for my 2nd Gen wagon.
  8. I have the service manual and it doesn’t show what I’m asking for
  9. I tried searching but couldn’t find any pictures of the dash, specifically the area under the steering column. I’m trying to piece back together my car and can’t remember where of these relays etc go. Appreciate any pictures you guys have
  10. Bumb if anyone runs into something similar innthe future it was the ground wire on the intake smh
  11. Before I purchase and new “use” harness for my 98 legacy I figured I’d try one last time to find out what the problem is. Car was fine before I put my coil overs on, took car off jack the stands it wouldn’t start. When I remove the key I still have a 6-7volts at the ignition (Black wire & Black/Blue). I bench tested everything even swapped ECUs, relays and still same issue. I’m down to it being a faulty wire somewhere in the harness that I can’t pinpoint. Any input will be helpful
  12. Bump......so finally got back to troubleshooting again and so here’s what’s working as it should Main Relay,Fuel Pump Relay and all connections going to the pump/ECU tested good with continuity and the pump works when I jump the fuel pump relay. I still have voltage going to my fuse box inside the car with the Key OFF and with my limited time I’m stumped. Any ideas as to what I should check next
  13. Finally had decent weather and time to troubleshoot. Tested the ignition switch and it’s good, and checked my main fuse box to see if anything was visablly wrong and saw nothing all fuses good. Any insight anyone???
×
×
  • Create New...

Important Information

Terms of Use