Jump to content
LegacyGT.com

holymahwah

Members
  • Posts

    13
  • Joined

Personal Information

  • Location
    Right where they're doing all that construction in NJ
  • Car
    MY08 spec B

holymahwah's Achievements

Rookie

Rookie (2/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Spotted this guy NB on the GSP this morning around 9:30ish, just past Kenilworth. Check out that wing... Was it you, LGT-NY???
  2. Spotted '09 PZEV in QSM around 2:30ish yesterday on the GSP heading south out of the Essex toll plaza. Young couple, CT plates. Wanted to wave, but ...
  3. I spotted myself on the GSP this morning going NB to 153. So I must still be around
  4. Negatory. USDM MY04-5 WRX rear diff has a 3.54 ratio while the front diff is 3.90. The transmission includes a 1:1.1 transfer gear connected to the center diff that only affects the rear driveshaft. If you're going to use a USDM WRX rear diff, you have to get a new R&P. Otherwise, you can source a USDM '91-'93 Legacy Turbo rear diff, which is a 3.90 R160 (some with viscous LSDs). Somebody on NASIOC also supplies what I think are JDM 3.90 R160 units (SpecC4U (?), a vendor from Canada, IIRC). Interestingly enough, the MY08 Spec B comes with this 1:1.1 transfer gear in the 6MT, too (according to the service manual). The rear end is an 3.54 ratio R180.
×
×
  • Create New...

Important Information

Terms of Use