Hey guy's! I have been roaming and doing A LOT of research for my 2006 legacy gt for my future build plans with the motor and tranny. I am going to be getting a fully built motor from maxwell motorsports and doing a 6spd STI swap. Have read the heck out of this thread and especially the first page.. Anways I just wanted to verify with the parts list that I need
Will be going with recipe A because like the OP I would like the R180 rear diff which is stronger..
Does this all look right and everything that i need for the swap?...
Transmission options: 04/05 STI V7 Non DCCD JDM or earlier model Jdm V7
Rear diff options: 04/05 STI, possibly 07-09 Legacy GT R160**?
Rear axles: 07-09 Spec B (axles 28421AG03B, axle seals 806732200)
Front axles: Regular LGT***
Driveshaft: use a Spec B driveshaft, and replace the differential's input flange with the R160 flange. Or i could purchase a 2.5i 08+ automatic driveshaft?
6MT shift linkage from spec b..
6mt clutch fork
6mt clutch release shaft
6mt clutch slave cylinder
6mt clutch hose
6mt throw out bearing
6mt rear transmission mount
Reverse lock out cable (does this have to be spec b?)
R180 Diff mount from spec b?
Clutch fork shaft plug
Output Shaft Oil Seal
Clutch fork spring
Inner shift boot
Am i missing anything? or what I have listed too much?
Thanks guys
