Jump to content
LegacyGT.com

needforsleep

Members
  • Posts

    181
  • Joined

Personal Information

  • Location
    Houston

needforsleep's Achievements

Collaborator

Collaborator (7/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Woot. I can finally join this thread. I can't figure out how to make high beam just high beam and not DRL and high. Currently, I have it wired so that the LED turns on once the ebrake is down and remains on until ebrake comes back up. High beam behaves like stock (low power DRL and then high beam when engaged). Any ideas please? My car is a 2008 This is my DRL:
  2. 245/35/18 KDW's on 18x9 Volk TE37's from 4 years ago.. Now: 265/35/18 Pilot Super Sports on 18x9.5 Advan RZII's
  3. Not as low as I use to be.. but still pretty low imo running 265/35/18's I can't believe it has been almost 7 years since this set up..
  4. Thanks CrazyGoat. I think it was the ROM I was running. Switched ROMs and now everything is back to normal.. Yay. I had the screen awake while charging enabled before but it still wouldn't turn on screen when power is connected.
  5. Dumb question but I can't seem to figure it out. I am powering my nexus with the usb cable and a car charger.. How do I get the screen to automatically turn on when power is connected? I'm using AutomateIt to turn on GPS, Wifi and start apps when power is connected and do the opposite when it turns off + turning off screen but I can't get it to power on the screen when power is connected.
  6. Okay, thanks guys for letting me know about cutting/removing a fin. I assumed that's what I had to do but I wanted to ask before I cut more things up.
  7. I had a question.. How flush did you guys mount the nexus 7 to the screen opening on the bezel? When I have the screen as flush as I can get it to the bezel I cannot move the vents up or down but they will go left and right. I am using a normal navigation bezel. I also do not understand how you guys who did not do CrazyGoats power relocation mod run cables from the nexus 7`s factory charge port. I tried running cables but they hit the vent fin.. Am I missing something?
  8. Thanks to OP and the_3d_man for posting this write-up and the pics of the 07+ difference. I didn't take out the duct on my 08 though. I just pushed mine back
  9. not completely "bolted" in though.. the idea seems to go along with what you want.. http://legacygt.com/forums/showthread.php/has-anyone-done-ipad-integration-yeti-144684.html?t=144684&highlight=ipad
  10. Nvm, been doing more reading and I wouldn't recommend using peel and seal
  11. Read on other forums that it works pretty good. Some say it works better than original Dynamat. Just have to apply it properly so it doesn't fall off. I would try it.. at $12 it can't hurt that much to try.
×
×
  • Create New...

Important Information

Terms of Use