07 legacy radio removeable

[Legasee07]

Any body know how to remove the radio and the wood grain around the radio? is thier any screws or are they all clips? sorry i serched but i cant find anything on the 07 only 05...i already removed the top section which consisit of the cubby hole, and digial display but cant figure out the whole radio and changeholder/ cig lighter outlet

[lookslikeanevo]

you need to remoe the center console first, then its legos from there...really easy

[bmorrisj]

pop off the shifter trim.... that'll start you because you can see screws from there...

[lookslikeanevo]

pop off the shifter trim.... that'll start you because you can see screws from there...

isnt hat part of the center console?

[bmorrisj]

its a long center console... :lol: like the 94ish honda accord you start with the cup holders :lol:

[Legasee07]

ohh okay thanks alot guys..

[Legasee07]

hey i removed the cup holders but thiers no screws thier :icon_conf , anyboy else know? do i have to take off the woodtrim on the sides? i pulled had but no budge, dont want to brake it if its screwed in

[ShockerGT]

http://www.jazzyengineering.com/Installation_Manual_1-2.pdf

starts on pg 2 on how to remove it

[Legasee07]

Excally what i needed..Thanks alot, maybe make that page a sticky?? since i havnt seen it for the 07

[bmorrisj]

hey i removed the cup holders but thiers no screws thier :icon_conf , anyboy else know? do i have to take off the woodtrim on the sides? i pulled had but no budge, dont want to brake it if its screwed in


no need to remove the cupholders :lol: i was comparing to an accord, the stuff you have to take off just to get to the radio... :lol:

[sebberry]

Excally what i needed..Thanks alot, maybe make that page a sticky?? since i havnt seen it for the 07

A long flathead screwdriver and a flashlight helps to see the clip that holds the e-brake boot on. You will need to tug fairly hard on the leather to pop it up from where it connects to the top of the cupholders, but down at the bottom (about 6" from the top and right at the front) there is a clip that holds it on.

I'd also recommend using a good magnetic screwdriver as there are plenty of places for the screws to fall down and get lost (trust me, I've lost a couple down there :( )